-
Your shopping cart is empty!
End panel sections
Bottom and top deck
Long Guardrail
Fastenings
Plier
Wrench
2 People
STEP 1
Unpack all parts in the room where the bunk bed will be used.
STEP 2
Lay all parts on the floor. Be sure to protect the floor and the finish of the bed by laying everything on a soft carpet.
Lay the left headboard on the left side and connect the top and bottom bed decks and secure them with the provided small bolt and nut.
Attach the 2 bed decks to the right headboard and secure them with the provided small bolt and nut
Stand the bunk bed upright.
STEP 3
Attach both guardrails with the 8 long bolts (4 per guardrail).
Periodically check to make sure all screws, bolts and fastening devices are tight.
Cleaning
Mix a mild solution of gentle dishwashing liquid and water, apply to surface using a soft, clean cloth, then dry all surfaces with a soft, dry cloth. NO ABRASIVES, SCOURING PADS, STEEL WOOL, OR COARSE RAGS should be used to clean this fine furniture.
Keep these instructions for future reference.
Always use the recommended sized mattress to help prevent the likelihood of entrapment or fall.
Standard Twin Model Only use a mattress that is 37-1/2"-39" wide and 74"-75" long on upper bunk.
Twin XL Model Only use a mattress that is 37-1/2"-39" wide and 80” long on upper bunk.
Ensure thickness of mattress and foundation does not exceed 8.5" and mattress is at least 5" below upper edge of guardrails.
NOTE: THIS INSTRUCTION PAGE CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.